Glow and Go Travel Mirror

Step 1 - Ensure the mirror is fully charged by inserting the Micro-USB cable into the port on the back of the mirror and connecting it to a USB-compatible power source. Step 2 - Slide the switch to the ‘ON’ position. The indicator light will turn red while charging. Step 3 - Press the button on the face of the mirror to activate the lighting. Touch and hold the button to adjust the dimmable light settings. Step 4 - For a freestanding mirror, pull out the stand on the back and place horizontally or vertically on a flat surface. Step 5 - To magnify a specific area, place the magnetic mirror on the face of the mirror. Step 6 - It may take up to 3 hours for the mirror to be fully charged. Keep stored in the protective case for safekeeping.

To reduce the risk of burns, electric shock or fire: Read all instructions before using this appliance. To protect against electric shock, do not use while bathing or showering. Close supervision is necessary when any appliance is used near children or incapacitated persons. Do not operate this appliance if it is malfunctioning or damaged in any way. No repairs should be attempted by the consumer. Use the appliance only for its intended use as described in the instruction booklet. The use of attachments not recommended by STYLPRO™ may cause a hazard. Do not use outdoors or where aerosol (spray) products are being used or where oxygen is being administered. Make sure the Glow and Go Travel Mirror is not in a position where it can reflect sunlight. Reflected sunlight can cause fire. Do not use on a soft surface such as a bed, where openings may be blocked. Turn the switch to the `OFF` position before storing. Do not use the appliance in the bath. Do not place or store the appliance where it can fall or be pulled into a bathtub. Do not place or leave in water or other liquids. If the device falls into water, do not put your hand in the water.